Achille Mutijima Ndizihiwe
Blade Tip Technique for Turbine Blades Monitoring.
Rel. Teresa Maria Berruti. Politecnico di Torino, Corso di laurea magistrale in Ingegneria Meccanica (Mechanical Engineering), 2026
|
Preview |
PDF (Tesi_di_laurea)
- Tesi
Licenza: Creative Commons Attribution Non-commercial No Derivatives. Download (1MB) | Preview |
Abstract
The blades of turbines and compressors operate under demanding mechanical, thermal and aerodynamic loads. During operation, repeated vibrations can produce cyclic stresses that contribute to crack initiation, fatigue damage and, in severe cases, structural failure. Monitoring these vibrations is therefore important for ensuring safe and reliable operation and supporting effective maintenance. However, measuring blade motion while the blades rotate at high speed remains technically challenging. Blade Tip Timing (BTT) is a promising non-contact measurement technique developed to address this problem. Sensors positioned around the stationary casing record the instant at which each blade tip passes a probe. A vibrating blade arrives slightly earlier or later than expected, and this variation in its Time of Arrival (TOA) can be converted into an estimate of blade-tip displacement.
In this way, BTT can monitor the vibration of each blade in a rotating row while the machine is operating. Compared with traditional methods such as strain gauges, it does not require sensors or electrical connections to be attached directly to selected blades. Nevertheless, BTT measurements are indirect and generally under-sampled, meaning that dedicated processing methods and knowledge of the structural behaviour of the bladed disk are required to interpret them correctly. This thesis presents a literature-based review of BTT and its application to turbomachinery blade monitoring. The study connects the BTT measurement process with the dynamic behavior of blades, disks and bladed-disk assemblies, providing the mechanical foundation required to interpret blade-tip displacement measurements. Particular attention is given to extracting vibration characteristics from TOA data and using this information for stress and strain estimation, crack detection and damage assessment, together with the effects of mistuning. The literature indicates that BTT can provide valuable blade-by-blade information and reveal changes in vibratory behavior that may be associated with damage. However, because BTT does not measure stress, strain or damage directly, the reliability of the assessment depends on measurement accuracy, probe arrangement, signal-processing techniques, numerical models and, in many applications, comparison with a known healthy reference condition. The capabilities, limitations and practical requirements of the technique are therefore examined critically. Building on this review, the thesis proposes a compact educational test rig for demonstrating BTT under controlled laboratory conditions. A preliminary SolidWorks model and motor-selection study were developed to define the overall architecture, which combines a 3D-printed blisk with an independently driven excitation disk. Permanent magnets provide non-contact blade excitation, while optical probes and a once-per-revolution sensor support the BTT measurements. The proposed configuration offers a practical basis for future development but remains at the conceptual stage. Detailed component sizing, structural and modal analyses, rotor balancing, safety verification and experimental validation are therefore required before the rig can be constructed and operated.
Relatori
Anno Accademico
Tipo di pubblicazione
Numero di pagine
Corso di laurea
Classe di laurea
URI
![]() |
Modifica (riservato agli operatori) |
