Giorgio Giacomotti
Mechatronic Optimization, Fabrication, and Integration of a Robotic Arm for an Educational Humanoid Robot.
Rel. Marco Vacca. Politecnico di Torino, Corso di laurea magistrale in Mechatronic Engineering (Ingegneria Meccatronica), 2026
|
Preview |
PDF (Tesi_di_laurea)
- Tesi
Licenza: Creative Commons Attribution Non-commercial No Derivatives. Download (37MB) | Preview |
Abstract
This thesis presents the design, fabrication, and validation of an enhanced upper-limb manipulator starting from the open-source humanoid robot pib.rock, with the objective of improving its mechanical robustness, manufacturability, and usability as a low-cost research and educational platform. From a critical analysis of the baseline architecture, the work identifies the principal limitations of the original design, including the restricted capabilities of hobby-grade position-controlled servomotors, limited torque density, thermal saturation under sustained loads, underactuated tendon-driven hand kinematics, transmission losses caused by long Bowden cables, and the absence of proprioceptive and tactile feedback. These constraints significantly reduce manipulation accuracy, payload capacity, and the suitability of the platform for advanced mechatronic applications.
To address these limitations, the manipulator was redesigned through a series of targeted mechanical and electromechanical improvements
Relatori
Anno Accademico
Tipo di pubblicazione
Numero di pagine
Corso di laurea
Classe di laurea
URI
![]() |
Modifica (riservato agli operatori) |
